Replacement motor for slatted base TrioFlex Motor.
CHF 490.00*
Replacement motor for slatted base TrioFlex Motor. Features2 motors for head and foot adjustmentPower supply unit with electronic mains cut-off (< 0.5W in standby) Emergency loweringWired remote controlThe motor is supplied with a power supply unit and wired remote control.
Slatted base side rail
CHF 15.00*
The side rail prevents the mattress from slipping sideways off the slatted base . It is clamped onto the cross slats.The appropriate size must be selected for slatted frames up to 100 cm and slatted frames from 120 cm with different slat thicknesses. If the holders are too narrow or too wide, they can be carefully adjusted to the slat thickness using pliers.Made of 6 mm chrome-plated metal wire with transparent end caps to protect against scratches.Depending on requirements, up to four side brackets can be used per bed.The side brackets are sold individually.Suitable for the slatted frame models:- Softsleep Trioflex- Swissbed Yverdon
Slatted base TrioFlex cable remote control
CHF 150.00*
With the TrioFlex wired remote control you can operate your Trioflex slatted base with motor.FunctionsBack and leg motor up / down simultaneouslyBack motor up / downLeg motor up / downButton for torch functionThe TrioFlex wired remote control does not require batteries. Insert the 5-pin plug into the corresponding socket on the motor. The remote control should then work.
Slatted base TrioFlex motor synchronisation cable
CHF 100.00*
The synchronisation cable is used to connect two individual Trioflex Motor slatted bases so that they work synchronously. This is particularly practical in double beds where both sides need to be adjusted equally.Under "Data sheets" on this page you will find the instructions for commissioning the synchronisation cable for the Trioflex Motor slatted frame. The instructions can be downloaded.
Slatted base TrioFlex radio remote control
CHF 290.00*
With the TrioFlex radio remote control, you can operate your Trioflex slatted base with motor wirelessly by radio.FunctionsBack and leg motor up / down simultaneouslyBack motor up / downLeg motor up / downButton for torch functionUnder "Data sheets" on this page you will find the instructions for commissioning the radio remote control for the Trioflex slatted base motor. The instructions can be downloaded.
Slatted frame foot bar
CHF 15.00*
The foot bar prevents the mattress from slipping off the slatted frame at the foot end. It is attached to the cross slats of the foot section. Can also be used as a headrest.The appropriate size must be selected for slatted frames up to 100 cm and slatted frames from 120 cm with different slat thicknesses. If the brackets are too narrow or too wide, they can be carefully adjusted to the slat thickness using pliers.Made from 6 mm chrome-plated metal wire with transparent end caps to protect against scratches.The foot stirrups are sold individually.Suitable for the slatted frame models:- Softsleep Trioflex- Swissbed Yverdon