Replacement motor for Softsleep slatted base TrioFlex Motor.
CHF 490.00*
Replacement motor for TrioFlex motor slatted frame. Features
- 2 motors for head and foot adjustment- Power supply unit with electronic mains isolation (0.5W in standby mode) - Emergency lowering- Wired remote controlThe motor is supplied with a power supply unit and wired remote control.
Slatted base side rail
CHF 15.00*
Size:
bis Breite 100 cm
The side rail prevents the mattress from slipping sideways off the slatted base . It is clamped onto the cross slats.The appropriate size must be selected for slatted frames up to 100 cm and slatted frames from 120 cm with different slat thicknesses. If the holders are too narrow or too wide, they can be carefully adjusted to the slat thickness using pliers.Made of 6 mm chrome-plated metal wire with transparent end caps to protect against scratches.Depending on requirements, up to four side brackets can be used per bed.The side brackets are sold individually.Suitable for the slatted frame models:- Softsleep Trioflex- Swissbed Yverdon
Slatted frame foot bar
CHF 15.00*
Size:
bis Breite 100 cm
The foot bar prevents the mattress from slipping off the slatted frame at the foot end. It is attached to the cross slats of the foot section. Can also be used as a headrest.The appropriate size must be selected for slatted frames up to 100 cm and slatted frames from 120 cm with different slat thicknesses. If the brackets are too narrow or too wide, they can be carefully adjusted to the slat thickness using pliers.Made from 6 mm chrome-plated metal wire with transparent end caps to protect against scratches.The foot stirrups are sold individually.Suitable for the slatted frame models:- Softsleep Trioflex- Swissbed Yverdon
Softsleep slatted base TrioFlex cable remote control
CHF 150.00*
With the TrioFlex wired remote control, you can operate your Trioflex slatted frame with motor.Functions:- Back and leg motor up/down simultaneously- Back motor up/down- Leg motor up/down- Button for torch function The TrioFlex wired remote control does not require batteries. Plug the 5-pin connector into the corresponding socket on the motor. The remote control should then work.
Softsleep slatted base TrioFlex motor synchronisation cable
CHF 100.00*
The synchronisation cable is used to connect two individual Trioflex Motor slatted bases so that they work synchronously. This is particularly practical in double beds where both sides need to be adjusted equally.Under "Data sheets" on this page you will find the instructions for commissioning the synchronisation cable for the Trioflex Motor slatted frame. The instructions can be downloaded.
Softsleep slatted base TrioFlex radio remote control
CHF 290.00*
With the TrioFlex wireless remote control, you can operate your Trioflex slatted frame with motor wirelessly via radio. Functions: - Back and leg motor up/down simultaneously - Back motor up/down - Leg motor up/down - Button for torch function Under "Data sheets" on this page, you will find instructions for commissioning the wireless remote control for the Trioflex motor slatted frame. The instructions can be downloaded.
Softsleep slatted frame TrioFlex foot system Height 25 cm
CHF 190.00*
Size:
90 x 200 cm
Foot system compatible with Trioflex slatted frames: - Softsleep TrioFlex KF slatted frame- Softsleep TrioFlex Motor slatted frame The foot system consists of 4 feet, 2 crossbars, four retaining fittings and the necessary screws. The foot system has a total height of 25 cm.Size:Only the width is decisive when it comes to size; the foot sets also fit shorter or longer slatted frames.